Is There a Cure for Brew Rig Envy?

 

IMG_2539So, I got to spend some quality time with this sexy beast yesterday. There’s no surer route to a serious case of Brew Rig Envy than getting your hands on a rig like this. Alas, no cure is known for BRE, save serious monetary outlay.

This is the Blichmann Top Tier brew stand and burners, fitted with 20 gallon kettles from Stout Tanks and Kettles, a single March pump, and Blichmann’s Therminator plate chiller. The Stout kettles feature Tri Clover fittings throughout, and the boil kettle has a tangential inlet for whirlpooling. It is a beautiful setup. I’ve been planning a single tier stand for my next rig, and seeing this setup in person has me on the verge of changing my mind.IMG_2532

My brew buddy whose garage it resides in has had the Top Tier for a while and just received the kettles and was kind enough to let me help begin setting up his brewery. If you are unfamiliar with the Top Tier, it is a modular system that allows Blichmann burners, shelves and other components to mount on a vertical mast. This modular nature means that you can configure the system to fit your needs. In this case, we configured it with a gravity fed hot liquor tank, and a single pump. The pump will circulate the wort in the direct fired mash tun as well as provide the whirlpool for the brew kettle, and circulate the wort through the plate chiller.

After considerable tinkering and test fitting, we established the height of the three burners and fitted all the ball valves and Tri Clover fittings on the kettles, pump, and chiller. A single gas rail will fuel the three propane burners, so a trip to Home Depot was in order to have the black gas pipe for the rail cut and threaded. I called it quits for the evening once the gas rail was assembled.

I got a report from brew buddy this morning that he had to take one of the burners back off in order to get the mounting brackets for the gas rail in place. That seems to be the nature of the Top Tier. It is a blank canvas, so the potential exists for a lot of mounting, removing, and re-mounting until an ultimate configuration is realized.

The next step will be installation of a sight glass for the hot liquor tank, measuring and cutting the silicon tubing, and a test run and leak check with water. Then we’re ready to brew, right? Not so fast there. Next step after the leak test will be calibrating the sight glass, measuring the dead space in the mash tun and boil kettle, and estimating the wort loss due to the liquid left in the tubing, pump, and chiller. Then we’ll take all those numbers and create an equipment profile for Beersmith. Then we’ll be ready to brew.

In the meantime, I’m having fever dreams about tri clover fittings and large stainless kettles. The condition is incurable. Where’s my checkbook?

 

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s